Removing The Battery; Auxiliary Handle - Würth EWS 18-A Manual De Instrucciones

The Lithium-Ion battery is protected against deep dis-
charging by the "Electronic Cell Protection (ECP)".
When the battery is empty, the machine is switched off
by means of a protective circuit: The inserted tool no
longer rotates.
Do not continue to press the
WARNING
On/Off switch after the
machine has been automatically switched off.
The battery can be damaged.
The battery is equipped with a NTC temperature con-
trol which allows charging only within a temperature
range of between 0 °C and 45 °C. A long battery
service life is achieved in this manner.
Observe the notes for disposal.

Removing the battery

The battery 4 is equipped with two locking levels that
should prevent the battery from falling out when
pushing the battery unlocking button 5 unintention-
ally. As long as the battery is inserted in the power
tool, it is held in position by means of a spring.
To remove the battery 4, press the unlocking button 5
and pull out the battery toward the front. Do not
exert any force.
Battery Charge-control Indication
(see figure A)
The three green LEDs of the battery charge-control
indicator 23 indicate the charge condition of the bat-
tery 4. For safety reasons, it is only possible to check
the status of the charge condition when the machine
is at a standstill.
Press button 22 to indicate the charge condition. This
is also possible when the battery 4 is removed.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
When no LED lights up after pushing button 22, then
the battery is defective and must be replaced.
❏ Before any work on the machine itself (e. g.
Note: After breakage of the grinding disc during
operation or in case of damage to the attachment fix-
tures on the protection guard/power tool, the
machine must be sent immediately to a Würth-master
Service.
Protection Guard for Grinding
❏ Adjust the protection guard 9 in such a
Note: The encoding keys on the protection guard 9
ensure that only a protection guard that fits the
machine type can be mounted.
Protection Guard for Cutting
❏ For cutting with bonded abrasives, always
❏ Provide for sufficient dust extraction when
The protection guard for cutting 15 is mounted in the
same manner as the protection guard for grinding 9.

Auxiliary Handle

Capacity
2/3
❏ Operate your machine only with the auxil-
1/3
<1/3
Screw the auxiliary handle 6 on the right or left of the
Reserve
machine head depending on the working method.
Mounting the Protective Devices
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool. There is danger
of injury when unintentionally actuating the
On/Off switch.
Place the protection guard 9 on
the spindle collar. Adjust the
position of the protection guard
9 to the requirements of the
operation. Lock the protection
guard 9 tightening the locking
screw 8 with an allen key 3.
manner that sparking is prevented in the
direction of the operator.
use the protection guard for cutting 15.
cutting stone.
iary handle 6.
25