Safety Regulations - Atlas Copco Pionjar 120 Instrucciones Para El Operario

English

Safety regulations

These instructions contain important sections dealing with safety.
Special attention must be paid to all framed safety text that begins with a warning symbol (triangle) followed
by a signal word, as shown below
!
WARNING
!
CAUTION
Also observe the following general safety rules:
• Before starting the product, read through these instructions carefully.
• Also read through the red safety instructions before putting the product to use.
• For reasons of product safety, the product must not be modified.
• Use approved personal protective equipment.
• Use Atlas Copco Genuine Parts only.
• Replace damaged or worn plates.
• Only trained personnel may work on the product.
Data
Pionjär 120.......................Combined rock-drill and breaker
Pionjär 130.......................Breaker only
Pionjär 120AV ..................Combined rock-drill and breaker
Engine
Type .................................1-cylinder, two-stroke, air cooled
Cylinder displacement .....185 cc
Crankshaft speed.............2550-2650 rev/min (blows/min)
(loaded machine on concrete chisel)
Carburettor.......................Floatless, with manual needle valve
Ignition system .................Thyristor type, breakerless
Spark plug
(recommended) ...............Motorcraft AE-6, Bosch W7AC
Spark plug gap.................1.5 mm
Starter ..............................Magnapull
Fuel type ..........................Petrol, 90–100 octane, leaded
or unleaded
Oil type.............................Atlas Copco two-stroke oil or a
recommended two-stroke oil
Fuel mixture .....................Cast-iron cylinder 8%, 1:12
Tank volume.....................1.5 l
Fuel consumption ............1.3-1.5 l/h
Capacities, Pionjär 120, Pionjär 120AV
Max. drilling depth............6 m
Penetration rate................300-350 mm/min with 29 mm bit
.........................................250-300 mm/min with 34 mm bit
.........................................150-200 mm/min with 40 mm bit
Drill rotation speed...........250 rev/min
4
www.CrowderSupply.com • Toll Free: 888-883-5144
denotes a hazard or hazardous procedure which CAN lead to serious or
life-threatening injuries if the warning is not observed.
denotes a risk or risky procedure which CAN lead to personal injury or damage
to equipment if the caution is not observed.
Other data
Tool shank ..............22x108 mm
Weight
Pionjär 120 .............27 kg .............730 mm.........330 mm
Pionjär 130 .............25 kg .............700 mm.........330 mm
Pionjär 120AV.........25 kg .............760 mm.........390 mm
Connection of grinding machine - please see sepa-
rate instructions.
Declaration of noise and vibration emission
Pionjär models
Noise according to ISO 3744
dB(A) rel
L measured, r =
P
20µPa
1m
Vibration according to EN28662
Measured vibration
2
a m/s
value
Spread in method
2
ka m/s
and production
English
Length Width
120 130 120AV
104 104 104
20 19 20
5.0 5.0 5.0