Installing The Footswitch Holder (Optional Accessory); Final Inspection - Stryker 240-099-155 Manual Del Usuario

Installing the Footswitch Holder (Optional Accessory)

To install the Footswitch Holder:
1. Remove the Footswitch Holder from the box and inspect it for damage that may have occurred during
shipping.
2. Position the Footswitch holder on the left-side extrusion between the bottom of the handle and the top of the
IFU holder.
3. With the t-nuts oriented vertically, slide the t-nuts into the channel on the top and bottom of the Footswitch
Holder.
4. Using a 4mm hex tool, tighten the t-nuts until the Footswitch Holder is held firmly in place.

Final Inspection

To complete inspection:
1. Connect the cart power cord to AC supply mains and power the cart on by pushing the cart power button.
Confirm that the cart power button is illuminated.
2. Power the cart off, disconnect the power cord from AC supply mains, and wrap the power cord on the power
cord hook located on the rear door.
10 EN P41610 Rev. C