Toothbrush Handle; Brush Head - Philips SonicPro 30 Manual Del Usuario

16
English
Cleaning

Toothbrush handle

Brush head

Charger
- Triple tone of high-med-low means the pressure
sensor feature has been deactivated. The battery
level indicator light will blink amber 1 time to
confirm deactivation.
If you continue holding the power on/off button after
the three short beeps, the activate/deactivate
sequence repeats.
You should clean your SonicPro toothbrush regularly
to remove toothpaste and other residue. Failure to
clean your SonicPro toothbrush may result in an
unhygienic product and damage to it may occur.
Warning: Do not clean product or accessories
with sharp objects or in dishwasher, microwave,
with chemicals or in boiling hot water
Remove the brush head and rinse the metal shaft
1
area with warm water. Make sure you remove any
residual toothpaste.
Caution: Do not push on the rubber seal on the metal
shaft with sharp objects, as this may cause damage.
2 Wipe the entire surface of the handle with a damp
cloth.
Note: Do not tap the handle on the sink to remove
excess water.
Rinse the brush head and bristles after each use.
1
2 Remove the brush head from the handle and rinse
the brush head connection with warm water at
least once a week. Rinse the travel cap as often as
needed.
Unplug the charger before you clean it.
1
2 Wipe the surface of the charger with a damp cloth.