Safety Precaution; Installation Instructions - Beko ADV5810 Manual Del Usuario

GENERAL
Carefully read the following important information re-
garding installation safety and maintenance. Keep this
information booklet accessible for further consultations.
The appliance has been designed for use in the ducting
version (air exhaust to the outside - Fig.1B), filtering
version (air circulation on the inside - Fig.1A) or with
external motor (Fig.1C).

SAFETY PRECAUTION

1. Take care when the cooker hood is operating simulta-
neously with an open fireplace or burner that depend on
the air in the environment and are supplied by other than
electrical energy, as the cooker hood removes the air from
the environment which a burner or fireplace need for
combustion. The negative pressure in the environment
must not exceed 4Pa (4x10-5 bar). Provide adequate
ventilation in the environment for a safe operation of the
cooker hood. Follow the local laws applicable for external
air evacuation.
Before connecting the model to the electricity
network:
- Control the data plate (positioned inside the appliance)
to ascertain that the voltage and power correspond to
the network and the socket is suitable. If in doubt ask a
qualified electrician.
- If the power supply cable is damaged, it must be re-
placed with another cable or a special assembly, which
may be obtained direct from the manufacturer or from
the Technical Assistance Centre.
- This device must be connected to the supply network
through either a plug fused 3A or hardwired to a 2 fase
spur protected by 3A fuse.
2. Warning!
In certain circumstances electrical appliances may
be a danger hazard.
A) Do not check the status of the filters while the
cooker hood is operating.
B) Do not touch bulbs or adjacent areas, during or
straight after prolonged use of the lighting instal-
lation.
C) Flambè cooking is prohibited underneath the
cooker hood.
D) Avoid free flame, as it is damaging for the filters
and a fire hazard.
E) Constantly check food frying to avoid that the
overheated oil may become a fire hazard.
F) Disconnect the electrical plug prior to any main-
tenance.
G) This appliance is not intended for use by young
children or infirm persons without supervision.
H) Young children should be supervised to ensure
they do not play with the appliance.
I) There shall be adequate ventilation of the room
when the rangehood is used at the same time as
appliances burning gas or other fuels.
L) There is a risk of fire if cleaning is not carried out
in accordance with the instructions.
This appliance conforms to the European Directive
ENGLISH
EC/2002/96, Waste Electrical and Electronic Equipment
(WEEE). By making sure that this appliance is disposed
of in a suitable manner, the user is helping to prevent
potential damage to the environment or to public health.
The symbol on the product or on the accompanying
paperwork indicates that the appliance should not
be treated as domestic waste, but should be deliv-
ered to a suitable electric and electronic appliance recy-
cling collection point. Follow local guidelines when dis-
posing of waste. For more information on the treatment,
re-use and recycling of this product, please contact your
local authority, domestic waste collection service or the
shop where the appliance was purchased.

INSTALLATION INSTRUCTIONS

• Assembly and electrical connections must be
carried out by specialised personnel.
• Wear protective gloves before proceeding with
the installation.
• Electric Connection:
Note! Verify the data label placed inside the appliance: - If the symbol
no earth connection must be made on the appliance,
therefore follow the instructions concerning insulation
class II.
- If the symbol
the instructions concerning insulation class I.
Insulation class II
- The appliance has been manufactured as a class II,
therefore no earth cable is necessary. The plug must be
easily accessible after the installation of the appliance.
If the appliance is equipped with power cord without
plug, a suitably dimensioned omnipolar switch with 3
mm minimum opening between contacts must be fit-
ted between the appliance and the electricity supply in
compliance with the load and current regulations.
- The connection to the mains is carried out as follows:
BROWN = L line
BLUE = N neutral.
Insulation class I
This is a class I, appliance and must therefore be con-
nected to an effiecient earthing system.
- The appliance must be connected to the electricity
supply as follows:
BROWN = L line
BLUE = N neutral
YELLOW/GREEN =
The neutral wire must be connected to the terminal with
the N symbol while the YELLOW/GREEN, wire must be
connected to the terminal by the earth symbol
When connecting the appliance to the electricity supply,
make sure that the mains socket has an earth connection.
After fitting the ducted cooker hood, make sure that the
electrical plug is in a position where it can be accessed
easily. If the appliance is connected directly to the
electricity supply, an omnipolar switch with a minimum
contact opening of 3 mm must be placed in between the
two; its size must be suitable for the load required and it
- 27 -
appears on the plate, it means that
DOES NOT appear on the plate, follow
earth.
GB
.