Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Problem
Possible causes
F3-F8
Temperature sensor failure
F9-FE
Temperature sensor of the
IGBT failure.
E1/E2
Abnormal supply voltage
E3/E4
Abnormal temperature
E5/E6
Bad induction hob heat
radiation
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and
damages to the induction hob.
Technical Specification
Cooking Hob
Cooking Zones
Supply Voltage
Installed Electric Power
Product SizeD×W×H(mm)
Building-in Dimensions A×B (mm)
Weight and Dimensions are approximate. Because we continually strive to
improve our products we may change specifications and designs without prior
notice.
Installation
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be
preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select
heat-resistant work surface material to avoid larger deformation caused by the
heat radiation from the hotplate. As shown below:
What to do
Please contact the supplier.
Please contact the supplier.
Please inspect whether power
supply is normal.
Power on after the power
supply is normal.
Please inspect the pot.
Please restart after the
induction hob cools down.
CCV3SL60
3 Zones
220-240V~
7200W
590X520X56.5
560X490
26
Tabla de contenido
