installation
installation
Mounting bracket for DHF appliance replacement
32
|dhB-e ... sil electronic
9.5.10
Undersink installation with turned appliance cap
The appliance cap can be positioned on the back panel turned
through 180°. This particularly advantageous for undersink
installation. For this take the following steps:
»
Remove the user interface from the appliance cap by pressing
the locking hooks.
»
Turn the appliance cap and click the user interface into place,
ensuring that all locking hooks click into place. To install the
user interface more easily, press against the inner side of the
appliance cap (in the shaded area, see diagram "Appliance cap
for undersink installation").
User interface with faulty locking hooks.
Never install a user interface with a faulty locking
hook. Otherwise the safety of the appliance cannot
be guaranteed.
»
Plug the set value transducer cable into the "set temperature"
PCB; see "Commissioning".
»
Hook the appliance cap in at the bottom and pivot it up onto
the back panel. Ensure the all-round seal of the back panel sits
tightly by pushing the cap gently forwards and back.
»
Close the appliance with the screw in the cap.
Appliance cap for undersink installation
www.stiebel-eltron.com