Check For Completeness; Commissioning; Adjusting The Working Depth; Starting The Motor - AL-KO 3600 VE Manual De Instrucciones

3600 VE

Check for completeness

The packaging box contains the following parts:
„ Complete electrical lawn aerator
„ Operating and mounting instructions
Mounting of the guide rod assembly
„ The lawn aerator is packed in a completely
premounted state.
„ Remove the unit from the packaging.
„ Unfold the guide rod assembly and screw on the rod
tensioning knobs tightly (
„ Engage the guide rod assembly at the desired height
and screw it together with the joint tensioning knobs
( C Pos. 2). Make sure that the electrical and
control cables do not jam (

Adjusting the working depth

Attention!
Adjust the working depth only when the motor is
shut down.
Attention!
The working depth is preset and should be reset
only very carefully since penetrating the soil too
deep can cause damage due to an overloading of
the unit. Correct aeration depth < 3 mm.
„ The working depth must be adjusted to the
respective grass and soil conditions.
„ The adjustment should always be checked and
made on flat ground; in position D of the switching
lever ( E Pos. 3), the tips of the blade should
lightly touch the ground.
„ The working depth is variably adjustable using the
adjusting hand wheel (
depth depends on the blade wear and can be read
on the display (
switch off the unit and put the switching lever
( E Pos. 3) in position D (Drive).
„ After frequent use, the working depth can be
readjusted according to the wear of the blade.
„ For a cultivated, even lawn, a 1/4 revolution in
the "+" direction can be made using the adjusting
hand wheel ( F Pos. 8).
474 338_a
C Pos. 1).
B Pos. 9).
F Pos. 8). The set working
G Pos. 11). For this purpose,
Use
Cultivated lawn,
stone-free, soft soil
Stony, non-cultivated
soil
Uncultivated, strongly
mossy surface

Commissioning

„ Observe country-specific ordinances for operating
times.
Connecting the mains cable
„ Insert the coupling part of the mains cable onto the
plug of the safety pushbutton.
„ With the mains cable, form a loop and hang it into
the cable tension relief (
loop long enough that the cable tension relief can
glide from one side to the other.

Starting the motor

Danger - risk of injury!
Do not tip the unit during the starting procedure.
„ Make sure your feet are at a sufficient distance to
the cutter unit.
1. Before starting, set the switching lever (
to P (Park).
2. Press the start button (
same time, pull the safety bar (
the guide bar.
3. After starting the motor, release the start button.
4. Hold the safety bar against the guide bar.
Attention!
Hold the lawn aerator in the working position
during activation!
5. Push the switching lever (
position D (Drive); the aerator drum is switched to
the working position.
GB
Working depth
Set to ground height
Set to ground height, adjust
to a more shallow working
depth if stones are hit
Start with a low working
depth
H Pos. 7). Leave the
E Pos. 3)
D Pos. 10) and, at the
D Pos. 6) towards
E Pos. 3) forward into
14