Tabla de contenido
Idiomas disponibles
Idiomas disponibles
10
English
Using the appliance
1
Make sure the AirFloss Ultra is switched on. If it is off, press and
release the power/mode button to switch on the appliance. (Fig. 8)
You can change the modes to have the desired amounts of bursts
each time you press the activation button (Fig. 9). For optimal
results, use the triple burst mode (the default setting) from both
the outside and inside of your teeth.
To change modes, press the power/mode button to cycle through
the modes until you reach your desired mode. The LEDs show the
selected mode:
-
Single burst: 1 LED (Fig. 10)
-
Double burst: 2 LEDs (Fig. 11)
-
Triple burst: 3 LEDs (Fig. 12)
Note: The AirFloss Ultra remembers what mode was selected last
and it is ready for the next use. If your AirFloss Ultra becomes fully
drained of power, it will go back to the triple burst default mode
once it has been recharged.
2 Place the nozzle tip between two teeth at your gum line.
Slightly close your lips over the nozzle when it is in place, to avoid
splashing. (Fig. 13)
3 Press the activation button to deliver 1-3 bursts (depending on the
selected mode) of air and micro-droplets of mouthwash or water
between the teeth. (Fig. 14)
4 Slide the nozzle tip along the gum line until you feel it settle
between the next two teeth.
5 Continue this procedure for all spaces between your teeth,
including behind your back teeth. (Fig. 15)
Note: Refill the reservoir as needed.
Auto-burst function
Hold the activation button to deliver bursts continuously,
approximately one second between set of bursts.
Automatic shut-off function
The AirFloss automatically turns off if it has not been used for one
minute.
35_021_2143_1_Booklet_A6_v3.indd 10
09/08/16 09:52
Tabla de contenido
