SFA SANICUBIC 1 Instrucciones De Instalación página 54

UK
N°156 PRO
INSTRUCTIONS ONLY FOR QUALIFIED
PROFESSIONAL SPECIALISTS
1 5 WORK THAT MAY BE REQUIRED
ELECTRICAL INSTALLATION MUST BE CARRIED
OUT BY A PROFESSIONAL ELECTRICIAN
Before carrying out any other types of work, disconnect
the Sanicubic from the power supply.
UNIT ALARM
Possible preliminary maintenance operations on the unit
PROBLEM PROBABLE CAUSES
No motor starts and the mains No power
GREEN LED is off (*)
The LED war ning light is on 1 – Obstructed pump
2 – Blocked Pump
The LED flashing warning light Faulty detection system
Possible secondary maintenance operations
PROBLEM PROBABLE CAUSES
The motor does not start Faulty electronic card
but override works + The LED
warning light on
Pump running continuously
1 – Obstructed Dip tube
2 – Pump discharge height too
high
Pump starting up
The non-return valve is
intermittently
leaking or broken
Alarm reset
(*) override
(**) Warning: if pumping height is high, 90° elbows should be avoided.
REMOTE ALARM MODULE
FAULT WARNING LIGHT TABLE
Fault Probable
detected causes
RED LED ON 1- Blocked
+ YELLOW pumps
LED OFF 2- Blocked pumps
+ BUZZER 3- Problems with
the electric
motors
4- Too much
water flowing in
5- Faulty circuit
board
RED LED OFF Mains supply fault
+ FLASHING on the appliance
YELLOW LED
+ INTERMITTENT
BUZZER
SOLUTIONS
Check your electrical
connections
Press the override button
continuously to get the
pump working
Contact SFA after-sales service
SOLUTIONS
Contact SFA after-sales
service
1 – Remove obstruction from
the discharge pipe
2 – Check installation (**)
Clean or change the valves
The manual override (MO) button switches
off the red LED if the problem is solved
Remedial
action
1- Contact SFA
after-sales
service
Check the
electrical install
1 6 DISMANTLING
INSTRUCTIONS RESERVED EXCLUSIVELY
FOR QUALIFIED PROFESSIONAL SPECIALISTS
REMOVING A MOTOR
DISCONNECT THE UNIT FROM THE
POWER SUPPLY (the green indicator
light must be off).
The unit beeps to show that it
is no longer under power.
A
1
16
Unclip the cover.
Unscrew the collar on the
A
motor (the check valve
stays in place while the motor
is being repaired).
B
C
2
16
Unscrew the collar .
B
Remove the motor power
wires from the screw
C
connector.
D
E
3
16
Remove the screws from
D
the inspection cover.
Use the handle to lift the
E
motor carefully.
F
4
16
If the faulty motor has to be
sent back to the manufacturer.
PUTTING THE MOTOR
BACK IN PLACE
Re- assembly is the reverse
of the above.
Reconnect the motor power
wires (cf. illustration ).
2
16
Warning:
Comply carefully with the
colour code:
Blue wire with the blue wire
Brown wire with the brown
wire
Green wire with the green
wire
White wire with the white
wire
Connect the unit to the
power supply.
Carry out a complete test
for commissioning (cf.
paragraph ).
11