Electrical Safety - Black+Decker GL933 Traducción De Las Instrucciones Originales

ENGLISH
Labels on appliance
The following pictograms are shown on
the tool along with the date code:
Read the manual prior to
operation.
Wear safety glasses or goggles
when operating this appliance.
Wear suitable ear protectors
when operating this appliance.
Always remove the plug from
the socket before inspecting
a damaged cable. Do not use
your strimmer if the cable is
damaged.
Beware of flying objects. Keep
bystanders away from the
cutting area.
Do not expose the appliance to
rain or high humidity.
Directive 2000/14/EC
guaranteed sound power.

Electrical safety

This appliance is double
insulated; therefore no earth wire
is required. Always check that
the power supply corresponds to
the voltage on the rating plate.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Electric safety can be further improved
u
by using a highsensitivity 30 mA
Residual Current Device (RCD).
8
(Original instructions)
Features
This appliance includes some or all of the following features.
1. On/Off switch
2. Handle
3. Cable restraint
4. Power inlet
5. Secondary handle
6. Adjustment button
7. Tube
8. Spare spool storage
9. HDL cap
10. Guard
11. Line trimming blade
12. Spool housing
13. Cutting line
14. Edge wheel
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting the guard (fig. A & B)
Remove the screw (15) from the guard (10).
u
Place the guard (10) onto the tool as shown.
u
Firmly press the guard until it snaps into place.
u
Secure the guard with the screw.
u
Tighten the screw.
u
Warning! Never use the tool unless the guard is properly
fitted.
Attaching the secondary handle (fig. C)
Press in and hold the adjustment button (6) on the side of
u
the main body.
Slide the secondary handle (5) in place over the
u
adjustment button (6).
Warning! Ensure that the teeth on the button are correctly
aligned in slots in the handle and that the handle is secure.
Adjusting the position of the secondary handle
(fig. D)
The secondary handle (5) can be adjusted to provide optimum
balance and comfort.
Press in the adjustment button (6) on the left side of the
u
handle.
Rotate the second handle (5) into the required position.
u
Release the adjustment button (6).
u
Warning! Ensure that the teeth on the button are correctly
aligned in slots in the handle and that the handle is secure.
Adjusting the height of the tool (fig. E & F)
This tool has a telescopic mechanism, allowing you to set it to
a comfortable height. There are multiple height settings.