Troubleshooting Guide - Heath Zenith DualBrite 4115 Instrucciones De Instalación

SPECIFICATIONS
Range . . . . . . . . . . . . Up to 30 ft. (9.1 m)
Sensing Angle . . . . . . Up to 150°
Electrical Load . . . . . . See rating on fixture for
Sensor Capacity . . . . Up to 360 Watts (3.0
SYMPTOM POSSIBLE CAUSE
Light will not
1. Light switch is turned off.
come on.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker
4. Daylight turn-off is in effect
5. Incorrect circuit wiring, if this is
6. Re-aim the sensor to cover
Light comes on
1. Light control may be installed in
in daylight.
2. Light control is in Test. (Set
Light comes on
1. Light control may be sensing
for no apparent
reason.
2. Sensitivity is set too high. (Re-
206872-01
[varies with surrounding
temperature]
maximum wattage
A.) Maximum Tungsten
Incandescent

TROUBLESHOOTING GUIDE

is turned off.
(recheck after dark).
a new installation.
desired area.
a relatively dark location.
control switch to an ON-TIME
position.)
small animals or automobile
traffic (re-aim sensor).
duce sensitivity.)
Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO, and
Time Delay . . . . . . . . 1, 5, 10 minutes
D B Timer . . . . Off, 3, 6 hours, dusk-to
®
ual rite
HeathCo LLC reserves the right to discontinue
products and to change specifications at any
time without incurring any obligation to incorpo-
rate new features in products previously sold.
SYMPTOM POSSIBLE CAUSE
Light stays on
1. The sensor is pointed toward
continuously.
2. Light control is in Manual Mode.
3. Light control is in D
4. Sensitivity is set too high. (Re-
Light flashes on 1. Heat being reflected from other
and off.
7
MANUAL MODE
dawn
a heat source like an air vent,
dryer vent, or brightly-painted
heat-reflective surface. (Re-aim
sensor.)
(Switch to Auto.)
ual
mode.
duce sensitivity.)
objects may be affecting the
sensor. (Re-aim sensor.)
B
®
rite