Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. Rotate the mounting plate so the wire path
is on the upper right. Note: The wire path
on the mounting plate must be located as
shown below to allow the wires on the back
of the fixture to pass through.
5. Reinstall the fixture mounting screws and
attach the mounting plate to the junction
box as shown.
Wire Path
Ground Screw
Fixture Screws
As Shipped
WIRING
Note: All wiring should be run in accor-
dance with the National Electrical Code
through conduit or another acceptable means.
Contact a qualified electrician if there is any
question as to the suitability of the system.
CAUTION: DO NOT connect the RED
wire unless you want to control other
lights from the motion sensor.
Black
Green or
Bare
White
One Motion Light
206872-01
Wire Path
Flipped and
Rotated
Light
Fixture
3
White
Black
Green
or Bare
Two Motion Lights
Twist the junction box wires and the fixture wires
together as shown below. Secure with wire
connectors. If you have a metal junction box,
you may not need the green "pigtail". If you are
unsure about the grounding method, consult
your local building code.
Connect the fixture wires to the wires in the
junction box. Twist the wires together and secure
with wire connectors.
Recommended Grounding Method
Use a green ground "pigtail" (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire con-
nector. Secure the other end of the "pigtail" with
the GND screw on the mounting plate.
Black to black
Light
Light
Fixture
Fixture
White to white
Tabla de contenido
