Heath Zenith 5651 Instrucciones De Instalación

Model 5651
READ ALL INSTRUCTIONS CAREFULLY BEFORE BEGINNING INSTALLATION.
NOTE: All wiring must be run in accordance with the National Electrical Code (Canadian Electrical Code in Canada) through
conduit or another acceptable means. Contact a qualified electrician if there is any question as to the suitability of
the system.
Lamp in Fixture Contains Mercury. Dispose According
to Local, State, or Federal Laws.
WARNING: Turn power off at the fuse or circuit
breaker.
IMPORTANT: This fixture is manufactured with an elec-
tronic ballast with end-of-life protection. Power must be
shut off at the fuse or circuit breaker before installing
fixture or when replacing the fluorescent lamp. If fixture
does not operate after installation, shut off power, wait
10 seconds, and turn power back on. This will reset the
protection circuitry.
1. Select a location on a flat wall with structurally sound wood
and from 10 to 25 feet (3 to 7.6 m) from the ground. The wood
should be at least one inch thick to safely secure the fixture.
2. Using the mounting template as a guide, mark the 3 mounting holes.
We suggest drilling 3/16" (4.8 mm) pilot holes for the lag screws.
3. Install the two bottom lag screws first. Screw in the lag screws
so that there is about 3/8" (9.5 mm) of space under the head.
4. Place the fixture on these two screws and install the top lag
screw. Tighten the top lag screw first, then tighten the remain-
ing lag screws.
5. Secure your outdoor cable or flexible conduit to the cover plate
with a fitting in accordance with the National Electrical Code
(Canadian Electrical Code in Canada).
6. Thread the black and white fixture wires through the hole in the cover plate as shown.
7. Connect the fixture wires to the service wires (black to black
and white to white).
8. This fixture must be connected to ground. Secure the service
ground wire under the head of the green ground screw.
9. Install the cover plate. Secure with the two screws, washers,
and nuts provided.
10. Install the reflector/lens assembly. Secure with the two screws
provided. IMPORTANT: Do not turn power on to fixture
until the bulb has been installed.
11. Screw in the 65 watt compact fluorescent lamp provided (E39
Mogul base).
To test operation during daylight, cover the photocontrol with black
electrical tape. Turn on the power. The light should come on immedi-
ately and will take up to ten minutes to reach full brightness. Uncover
the photocontrol and your unit will operate automatically—on at
dusk, off at dawn.
© 2012 HeathCo LLC
Compact Fluorescent Dusk-to-Dawn
Installation Instructions
65 Watt Security Light
CAUTION: Do not use any other wattage lamps
in this fixture.
IMPORTANT: Power must be turned off before replac-
ing lamp. Wait 10 seconds after bulb is installed before
turning power back on.
ATTENTION: When removing, grasp lamp by the base. Do
not grasp glass lamp to remove.
To test operation during daylight, cover the photocontrol with black
electrical tape. Turn on the power. The light should come on im-
mediately and will take up to ten minutes to reach full brightness.
Uncover the photocontrol and your unit will operate automatically—
on at dusk, off at dawn.
Photocontrol
Lens/Reflector
Assembly
Ground Screw
Cover Plate
Fixture Wires Thru
This Hole
Figure 1
203496-01A