Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Do not remove any tool control elements (e.g.
■
trigger, workpiece contact), do not modify
them and do not render them inoperative in
any other way.
Do not use the tool, if a part that belongs to the
■
tool control elements (e.g. trigger, workpiece
contact), is not operational, is disconnected,
has been modified or is not working correctly.
Always assume that the tool contains fasteners.
■
Only activate the tool when it is firmly against
the workpiece.
Respect the tool as working equipment.
■
Do not play around with the tool.
■
Remain alert, concentrate on the work and
■
apply common sense when working with the
tools.
Do not use the tool if you are tired.
■
have consumed drugs or alcohol or are under
■
the influence of medicines.
Do not drive fasteners in above other fasteners.
■
This could result in the fasteners being de-
flected leading to injuries.
After driving in a fastener, the tool may jump
■
back ("recoil"), which means it moves away
from the working surface. To reduce the risk of
injury, you should always be prepared for a
recoil in the following way:
• Always maintain control over the tool.
• Allow for the recoil in a controlled manner,
so that the tool can move away from the
working. surface.
• Keep your face and other body parts away
from the tool openings.
Take care when working near to the edge of a
■
working surface or at steep angles to prevent
ricocheting of fasteners, spalling, splintering or
flying apart, all of which could lead to injuries.
Do not load any fasteners into the tool if one
■
of the control elements (e.g. trigger, workpiece
contact) is currently activated.
When fastening roofs or similar inclined
■
surfaces, start at the bottom part and work
gradually upwards. Working downwards is
hazardous, because you could loose your
footing. Never fire the tool into free space. This
prevents any dangers resulting from fasteners
flying around and excess loading of the tool.
Do not use the tool as a hammer.
■
This tool may only be used for the intended
■
purpose.
Safety instructions
If the device is not being used, store in a dry
■
place away from children.
Foreseeable dangers and warnings in respect of
the general use of the tool are described below.
Assess the specific risks that could arise from each
use separately.
Danger of projectile parts
During operation, ensure that the fasteners
■
penetrate the material correctly and cannot be
fired/deflected in the direction of the operator
and/or other people.
Fragments from the workpiece or from the
■
fastening or bundle system may be ejected
during operation.
When operating the tool, always wear
■
impact-resistant safety glasses with side
protection. The risks for other persons must be
assessed by the operator.
Take care when using tools without a work-
■
piece contact, as these can be unintentionally
fired resulting in injury to the operator and/or
bystanders.
Ensure that the tool is always securely against
■
the workpiece and cannot slide.
Dangers during operation
Hold the tool firmly and be ready to counteract
■
both normal and sudden movements, e.g.
recoils.
Always maintain a balanced posture and
■
secure footing.
Use of suitable safety glasses; appropriate
■
safety gloves and protective clothing are
recommended.
Dust mask, safety helmet, safety shoes and
■
other personal protective equipment are
required in some working environments.
Employer, tool owner and operator must
enforce the wearing of the personal protective
equipment necessary for the specific working
environment by all employees.
The operating instructions provide infor-
■
mation about the fasteners.
19
Tabla de contenido
