Pasador De Sutura Ideal; Descripción - Johnson & Johnson DePuy Mitek IDEAL Manual Del Usuario

Ocultar thumbs

Contenido

página de 45

/ 45
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

• The 3/0 nitinol shuttle should be retracted when

pushing the needle through tissue. Failure to retract

the 3/0 nitinol shuttle could result in device damage

and/or patient injury.

• Do not apply excessive force to the needle shaft, as

excessive force could bend or damage the needle

shaft and may limit the function of the device.

INSTRUCTIONS FOR USE

Read the Instructions For Use in its entirety prior to using

the device.

1. Inspect the IDEAL Suture Shuttle and 3/0 nitinol

shuttle prior to use to ensure proper mechanical

function

2. Check to ensure proper function by deploying the

shuttle loop through the tip of the instrument shaft.

3. Retract the shuttle loop into the needle tip of the shaft

(at least 5mm). The IDEAL Suture Shuttle is now

ready for use.

LOADING THE IDEAL SUTURE SHUTTLE

1. If the shuttle needs to be re-loaded into the device:

a. Hold the device so that the thumb wheel is facing

upward;

b. Insert the loop end of the suture shuttle into the

aperture distal of the thumb wheel. Advance

approximately 8-10cm of the shuttle into the hole;

c. Hold the shuttle firmly by pressing down on the

shuttle on top of the thumb wheel;

d. Pull the remainder of the shuttle firmly and slide

the length of the shuttle along the handle below

the thumb wheel into the shuttle loading slot, which

runs on the side and length of the handle;

e. Pull the shuttle firmly sideways into the shuttle

loading slot until the shuttle "snaps" through the

slot window and is loaded into the hollow handle of

the device;

f. Use the thumb wheel to advance the shuttle until

the loop end protrudes out of the tip of the needle;

g. Go to step 1 of the Instructions For Use.

STORAGE

Store in a cool dry place.

ESPAÑOL