Utilitech 1/2 HP-C Instrucciones De Instalación página 7

Cement as many sections and couplings of rigid 1"
STEP
PVC pipe needed to connect the 1" male PVC adapter
17
in the discharge tee to the 1" male adapter on the tank
cross inlet. Set pressure in the diaphragm pressure
tank to 2 pounds less the cut-in pressure of the pump.
The cut-in pressure of these pumps is factory preset
to 20 PSI. If this cut-in setting has not been changed,
then the diaphragm pressure tank should be set to 18
PSI. Total installation should look like the shallow well
drawing below.
To prime, remove plug
STEP
from the top of pump
18
case. Fill piping and
pump with water until
the water overflows
from the top of pump
case. Replace plug and
tighten to seal. Install
pressure gauge. Open
a faucet or two in the
house. Start motor. If
pump is offset from well
4 feet or more, it may take a few minutes for pump to
prime. Failure to prime in 5 minutes: Stop motor,
remove pressure gauge plug from discharge tee, add
more water, try again.
3139, 3134, 3125, 3124
Shallow Well
Installation
3121 Convertible
Shallow Well
Installation
Check Valve
Ejector
Foot Valve
7
PROCESS B. continued.
Check
Valve
# 3139
# 3134
# 3125
# 3124