Idiomas disponibles
Idiomas disponibles
Attaching tool
The tool holder enables the tool to be
changed without any tools.
Pull out the mains plug.
Press and hold down the spindle lock (1.).
Push tool or tool support onto the tool
holder (tongue and groove form fit) (2.).
Press the tool downwards against the
spring pressure (3.) and turn clockwise (4.).
The tool holder is locked.
NOTE
The tool holder has a width of 50 mm.
Depending on the tool width, several tools
must be attached or differences in width
must be equalised with the spacer rings.
Example:
Polishing wheel 50 mm
wide:
Buffing wheel 10 mm
wide:
Insert the mains plug into the socket.
Switch on the electric power tool (without
locking the button) and leave it running for
approx. 30 seconds. Check for imbalances
and vibrations.
Switch off the electric power tool.
26
1 tool
4 tools and
spacer rings
TRINOXFLEX BRE 8-4 / BSE 8-4 / FBE 8-4
Using the parallel guide
The parallel guide ensures exact straight
running when machining profiles.
Loosen the locking screw on the parallel
guide (1.).
Adjust the parallel guide (2.).
Re-tighten the locking screw.
Work instructions for the burnishing
attachment
CAUTION!
When the appliance is switched off, the
grinding tool continues running briefly.
Machining flat areas:
Hold electric power tool with both hands.
To give the surface a decorative finish:
Carefully place the electric power tool on
the area to be machined and move the
power tool forwards and backwards in
a linear motion.
Capítulos
