Flex BME 8-4 Instrucciones De Funcionamiento Originales página 27

TRINOXFLEX BRE 8-4 / BSE 8-4 / FBE 8-4
Belt sander attachment BRE 8-4
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Attaching or changing the sanding belt
CAUTION!
Observe the specified running direction of
the belt! Running direction must correspond
with the arrow on the gear head.
Pull out the mains plug.

Press the swing arm towards the rubber

drive roller and hold down (1.).
Place the sanding belt over the rollers (2.).

Release the swing arm.

Check that the belt is situated fully on the

rollers.
Adjusting the handle
Bring the handle into position on the thread.
Change the rollers
Drive roller:
Press and hold down the spindle lock (1.).

Loosen the drive roller against the

direction of rotation and pull off (2.).
Fit a new drive roller and tighten in

direction of rotation.
Release spindle lock.

Idler:
Loosen bolt using hexagon key and pull off

idler (3.).
Fit new idler and tighten.

Work instructions for the pipe belt
sander attachment
NOTE
When the appliance is switched off, the
grinding tool continues running briefly.
A belt sander has the following advantages
over a grinding disc:
– cool sanding,
– clean finish without grooves,
– high stock removal rate,
– high productivity on account of large angle
of contact (depending on diameter).
27