Idiomas disponibles
Idiomas disponibles
TRINOXFLEX BRE 8-4 / BSE 8-4 / FBE 8-4
Attach the handle
Attach the auxiliary handle to the thread in
position 1 or 2.
Adjusting the belt run
Adjust the belt run using the front screw on
the sanding arm. While the belt is running,
select the setting so that the belt runs in the
centre of the pressure roller.
Changing the sanding arm
To change the sanding arm, loosen the
three fastening screws.
Remove sanding arm.
Attach new sanding arm using the three
screws.
Operating instructions
NOTE
When the electric power tool is switched off,
it continues running briefly.
Sanding
When the locking screw (1.) is undone, the
swivel arm can be tilted up to 140° (2.).
As a result, the belt file can also be used
for surfaces which are difficult to access,
e.g. the insides of pipes.
Vary the removal rate via the contact
pressure. Ensure that the contact pressure
is even and not too heavy. If the contact
pressure is too high, the sanding belt may
slip off the roller.
Switching on and off
Brief operation without engaged switch
Push the switch rocker forwards and hold
in position.
To switch off the power tool, release
the switch rocker.
29
Capítulos
