Idiomas disponibles
Idiomas disponibles
Sanding:
NOTE
After placing the machine on the workpiece
and before switching it on, check that the
belt is situated fully on the rollers.
– Pipes are machined between the rollers
21 and 22.
– The angle of contact and the stock removal
rate can be varied by the contact pressure.
– The smaller the pipe diameter, the larger
the possible angle of contact. Up to 270°
are possible.
Sealing the surface:
Many manufacturers recommend sealing
finished surfaces with a protective spray
(see Flex stainless steel accessories).
For further information on the manufac-
turer's products go to www.flex-tools.com.
Belt grinder attachment FBE 8-4
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Attaching or changing the sanding belt
Pull out the mains plug.
28
TRINOXFLEX BRE 8-4 / BSE 8-4 / FBE 8-4
Remove handle (1.).
Swivel the housing cover to the side (2.).
Turn eccentric screw and release
sanding belt (3.).
Remove sanding belt (4.) (optional).
Pull on new sanding belt and position
centrally on the sanding arm (5.).
Tighten sanding belt by turning the
eccentric screw.
Close housing cover in front of the
housing again.
CAUTION!
Observe the specified running direction of
the belt! Running direction must correspond
with the arrow on the gear head.
Capítulos
