GB
Please read the operating instructions before operating the lamp for
the first time!
Important note:
Do not look straight in the burning lamp – risk of injury for the eyes!
Technical data
Art.
Number of LED:
Lithium-Ionen recharge-
able batteries:
Power output:
Charger input:
Charging time:
Active life:
Lifetime LED:
Degree of protection:
Storage temperature:
Operation temperature:
Charging procedure
Charge the lamp for 6–8 hours before first use.
Fully recharge the lamp before putting it away for
a long period of time.
Red LED (indicator light) warns that the lamp has
to be recharged. The lamp still works for approx.
5 minutes.
Put the lamp into the charging station.
Turn off the lamp while charging.
During charging the LED (indicator light) of the
lamp turns to RED.
The lamp can be used after the RED indicator
light turns to GREEN.
4
For your safety
0827 940 130
30 + 1 (Indicator Light)
7,4 V, 2.200 mAh
3 W
230 V, 50 Hz
approx. 3 hours
8–9 hours
up to 50.000 hours
IP65
–20 °C bis +70 °C
–5 °C bis +50 °C
Disclaimer
The information in these operating instructions can be
changed without prior notice. Würth does not accept
any liability for direct, indirect, accidentally or other
damages or consequential damages which result
from the usage or the application of the information
in these operating instructions.
Environmental protection
Do not dispose of the appliance with
domestic waste. Dispose of the ap-
pliance only via an authorized
waste management company or
your municipal waste management
organisation. Adhere also to the ap-
plicable regulations. In case of
doubt refer to your waste management organisation.
Recycle all packaging material in an environmentally
friendly manner. Batteries may not be disposed of
with domestic waste. Hand in used batteries at your
supplier or at a battery collecting point.
Technical changes reserved.
We accept no liability for printing errors.
Adolf Würth GmbH & Co. KG, Abt. PFB
Künzelsau: 06.2010