Disposal; Troubleshooting - AL-KO Easy Crush MH 2800 Instrucciones De Uso

en
CAUTION!
Damage to the machine due to improper
operation!
Incorrect handling can result in machine
damage!
Only feed materials to be shredded af-
ter the machine was switched on. Do not
feed materials to be shredded after the
machine was switched off.
WARNING!
Risk of injury due to revolving tools!
Revolving tools can cause severe hand
and finger injuries!
When working on the cutting tool, discon-
nect the machine from the mains con-
nection, wait for the tool to stop moving,
and wear protective gloves.

TROUBLESHOOTING

Malfunction
Motor does not start.
Machine does not pull in
materials to be shredded.
Materials to be shredded
are not properly cut.
Motor switches off.
Unusual noises.
Rattling on the machine.
20
Possible cause
Grass catcher missing or not lo-
cked.
Mains socket (house installation)
defective.
Extension cable defective.
Grass catcher overflowing (mate-
rial backing up in the cutting unit).
Shredder blade clogged with wet
materials to be shredded.
Blades dull or damaged.
Motor protection switch switched
off due to cutting disk overload or
blockage.
Screws on the motor, its mount,
the carriage or the shredder blade
are loose.
Working behaviour and working technique
WARNING!
Risk of injury due to long materials to be
shredded!
Longer materials to be shredded can
strike out and cause injuries!
Maintain sufficient safety distance.
WARNING!
Risk of injury due to negligence!
Loss of balance due to negligence can
cause most severe injuries!
Never feed the shredder from an eleva-
ted position.

DISPOSAL

Do not dispose of old
equipment,batteries or accumulators
as householdwaste!
Product, packaging, and accessories
were made with recyclable materials, and
should be disposed of accordingly.
Solution
Push grass catcher in completely
and lock it.
Use different mains socket.
Check cable and replace it as nee-
ded.
Empty grass catcher and remove
materials to be shredded from the
cutting unit as needed, see "Re-
leasing a cutting disk blockage".
Remove clogging by feeding
branch material.
Turn or replace blades, see "Re-
placing/turning the shredder bla-
des".
The motor can be switched on
again after a cool-down phase of
approx. 5 minutes.
Re-tighten screws.
Easy Crush MH 2800