Operation; Basic Functions - Hilti PS 1000 Manual De Instrucciones

4.2 Settings
When operating a brand new tool you will first be requested to select the country-specific settings.
1. Use the 4-way controller to select the desired language and confirm your choice by pressing the "OK" button.
2. Make further settings using the 4-way controller and the "OK" button.
3. Use the "OK" button to confirm the settings made.
NOTE You can also use the "Skip" button to skip making these settings until the next time the tool is switched
on.
en

5 Operation

5.1 Displaying the operating instructions
1. Press the "Home" button for 5 seconds.
The operating instructions will be shown in the right context in the display. You can then browse through the
complete operating instructions.
2. The operating instructions can also be displayed from the settings menu by way of the "Help" function button.
3. To close the operating instructions, press the "Back" function button.

5.2 Basic functions

The function buttons can be used to select the available functions.
The 4-way controller can be used to shift the focus, change parameter values or, depending on the setting, shift the
cross hairs or change the layer thickness/depth, etc.
The "OK" button can be used to select the object in focus or to start data processing.
5.3 Quickscan detection
This function is used to indicate the position of objects in a concrete structure directly, during the scan. Objects lying
perpendicular to the scanning direction can be made visible in a plan view or cross-sectional view and their position
then marked directly on the surface.
1. Switch the tool on or use the "Home" button to go to the main menu.
2. Select "Quickscan detection".
3. Hold the scanner against the surface of the area to be scanned.
4. Start the scan by pressing the start/stop button.
A beep indicates the start of the scan and a red recording mark appears in the display.
5. Move the scanner to the left or right (at least 32 cm) over the surface to be scanned and back along the same
scanning path in order to locate concealed objects.
Read the position of an object using the center line in the display and mark this point on the surface of the
concrete at the upper marking notch between the wheels. Alternatively, use the broken lines to mark the position
of an object along the corresponding edge at the side of the tool.
Audible and visual warnings are emitted if the scanner is moved at a speed approaching the maximum permitted
scanning speed. If the scanner is moved too quickly the scan will be canceled.
12
Printed: 22.12.2017 | Doc-Nr: PUB / 5310430 / 000 / 02