Operation; Care And Maintenance; Troubleshooting; Disposal - Hilti DD-CR 1 Manual De Instrucciones

2. Disconnect the supply cord from the electric power
supply and disconnect the water supply hose.
3. Remove the core bit from the diamond coring machine
(see DD EC-1 operating instructions).
4. Release the water collector by pressing the button at
the top of the water collector (DD EC-1).
5. Detach the diamond coring machine from the drill
stand by turning the securing knob.

7. Operation

Read the DD-CR1 and DD EC-1 operating instructions
before using the equipment.
-NOTE-
Hold the lever securely and release the drill stand car-
riage lockbutton.

9. Troubleshooting

Fault
The pressure gauge indicator
points to the red area.

10. Disposal

Most of the materials from which Hilti power tools and accessories are manufactured can be recycled. The mate-
rials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrange-
ments for taking back your old electric tools and accessories for recycling. Please ask your Hilti customer service
department or Hilti sales representative for further information.
Should you wish to return the electric tool or accessory yourself to a disposal facility for recycling, proceed as fol-
lows: Dismantle the item as far as possible without the need for special tools.
Separate the individual parts as follows:
Part / assembly
Carriage
Adjustable plate
Vacuum baseplate
Columns
Grip
Pressure gauge
Vacuum valve
Hand wheel
Screws, small parts
Printed: 07.07.2013 | Doc-Nr: PUB / 5069650 / 000 / 00

8. Care and maintenance

The diamond coring machine must be disconnected
from the electric power supply.
8.1 Cleaning the drill stand
Clean the outer surfaces of the drill stand at regular inter-
vals with a slightly damp cloth. Do not use sprays, steam
cleaning systems or running water for cleaning. The two
guide columns should be lubricated lightly with Hilti Spray.
8.2 Maintenance
Check all external parts of the drill stand for damage at reg-
ular intervals and check that all controls operate faultlessly.
Do not operate the drill stand when parts are damaged or
when the controls do not operate faultlessly. If necessary,
have the equipment repaired at a Hilti service center.
8.3 Checking the drill stand after care and maintenance
After all care and maintenance work, the drill stand must
be checked to ensure that all safety equipment is fitted
and that it operates faultlessly.
Possible cause
Insufficient vacuum under the
baseplate.
Main material
Plastic
Aluminum
Aluminum
Steel
Plastic
Steel and plastic
Steel
Remedy
– Check the seal on the baseplate and
replace it if damaged or defective.
– Check that the working surface is
clean. Clean it if necessary.
– Check that the working surface is
smooth. The vacuum fastening
method cannot be used on rough,
uneven surfaces.
Recycling
Plastics recycling
Scrap metal
Scrap metal
Scrap metal
Plastics recycling
Plastics recycling
Scrap metal
11