• If the alarm is triggered, the alarm symbol is
displayed and an alarm will sound.
• Press UP (19), DOWN (22), SET (20) or
ALARM to stop the alarm.
Note – Snooze function
• While the alarm signal is sounding, press
the SNOOZE button (18) or LIGHT button
(21) to activate the snooze function. The
icon begins to ash on the display. The
alarm signal will stop for approximately 10
minutes, after which it will sound again.
• Press UP (19), DOWN, (22), SET (20) or
ALARM to stop the snooze function and
the alarm.
Temperature (Celsius/Fahrenheit)
• Press the UP button (19) to switch between
°C and °F for the temperature display.
• The weather station indicates a trend as to
how the values for the indoor and outdoor
temperature are likely to develop over the
next few hours.
Display
Atmospheric pressure (hPA/inHg)
Note – Snooze function
• While the alarm signal is sounding, press
the SNOOZE button (18) or LIGHT button
(21) to activate the snooze function. The
icon begins to ash on the display. The
alarm signal will stop for approximately 10
minutes, after which it will sound again.
• Press UP (19), DOWN, (22), SET (20) or
ALARM to stop the snooze function and
the alarm.
Note
Like all measurement values, atmospheric
pressure is subject to a certain measurement
tolerance.
• Press and hold the Set button (20) until the
time begins to ash.
• Press the Set button (20) repeatedly until hPA
or inHG appears on the display.
Trend
Increasing
Constant
Decreasing
• Press the UP button (19) or DOWN button
(22) to change the unit to inHG or hPA.
• The weather station gives a current value
trend for atmospheric pressure.
6.3 Weather trend display
Based on changes in the atmospheric pressure
and the data saved, the base station is able
to make weather forecasts for the next 12 to
24 hours.
Note – Weather trend display
The weather forecast function is not available
during the rst few hours of operation because it
requires data that is collected during operation.
The weather trend and the current weather are
displayed using four different symbols (1):
Symbol
6.4 Moon phases
The base station displays the current moon phase
with the following symbols:
New Moon
Waxing
Crescent
First quarter
Waxing
Gibbous
6.5 Backlight
• If you press the SNOOZE button (18) or
LIGHT button (21) in battery operation,
the display will light up for approximately
10 seconds.
• By repeatedly pressing the SNOOZE button
(18) or LIGHT button (21) in mains operation,
you can specify the brightness level of the
lighting and turn it off.
Weather
Sunny
Slightly cloudy
Cloudy
Rainy
Full Moon
Waning
Gibbous
Last quarter
Waning
Crescent
5