Tabla de contenido
Installation/Service mode
• 'NONE' will be displayed for the menu that setting modes don't support. In some cases, the setting may not be
possible or it may not be applied though it is set on the unit.
NOTE
• If communication initialization is needed after saving the setting, the system will reset automatically and
communication will be initialized.
Main
Sub
Menu
Menu
Wired remote
controller's option
1
function set /Check
1
Wired
1
2
remotecontroller's
option function set /
3
Check 2
Checking the
4
number of
connected devices
Setting desired temperature unit (Available only
5
when the temperature display is °C)
Reset to option setting default value of
0
1
Checking Micom code of wired remote controller
2
Checking version information of wired remote
2
1
Setting CONTROL
2
3 *1)
KIT option
3
4
View Master Set/
1
Check
4
2
Master CONTROL KIT
Set/Check
3
1
0
2
Reset
3
*1) When entering the main menu 3, set and check the unit address and then move to the sub menu.
The unit address will be displayed by blinking SEG 34 (Device ID) and SEG 1234 (Control Layer, Set Layer address).
*2) 1. Reservation No. 1 display, Main address setting and checking: Range of current main address (SEG 1, 2) and main
address setting: 0x00 ~ 0x4F (hexadecimal)
2. Reservation No. 2 display, Group address setting and checking: Range of current group address (SEG 1, 2) and group
address setting: 0x00 ~ 0xFE (hexadecimal)
Function
Cooling support Y / N
Selecting the standard
temperature of cooling and
heating
Selecting a standard sensor
of indoor temperature
Selecting Master/Slave
Checking current sensor
temperature value
Setting compensation
temperature value
The number of connected
device
wiredremote controller
controller
CONTROL KIT address Set/
Check
Basic Option Set/Check
Install Option Set/Check
Install(2) Option Set/Check 1234, 12
CONTROL KIT View Master
Set/Check
Check the Master CONTROL
KIT address
Master CONTROL KIT Set
Wired remote controller
factory Reset
Power Master Reset
Addressing Reset(Outdoor
unit Reset)
ENGLISH-33
SEG
Default
number
0 – Both cooling & heating
1
0
1 – Heating Only
0-Water Outlet temperature
2
0
1-Indoor temperature
0-Temperature sensor of wired
3
0
remote controller 1-External
temperature sensor
4
0
0-Master, 1-Slave
123
0
123
0
1,2
0
1
1
0-1˚C, 1-0.5˚C, 2-0.1˚C
1
0
0-Disuse, 1-Reset
1234, 4
-
1234, 34
-
1234
-
1234, 12
-
1234, 12
-
-
1234, 34
-
1234, 34
-
1
-
0-Disuse, 1-Use, 2-Reset
1
0
0-Disuse, 1-Reset
1
0
0-Disuse, 1-Reset
1
0
0-Disuse, 1-Reset
Range
Unit
-
-
-
-
-9~40˚C
-
-9.9~9.9˚C
0.1 ˚C
0~16
1
-
-
Micom code
-
Revision date
-
*2)
Option code
Option code
Option code
Address
Address
-
-
-
Tabla de contenido
