Switching On And Off - Black+Decker MTRS10 Manual Del Usuario

Insert the shank of the blade fully into the blade
u
clamp (11).
Push the blade clamp lever (12) down to lock
u
the blade clamping mechanism.
Note: The blade can be installed with the teeth up
to assist in flush cutting
Removing the saw blade (fig. A)
Warning! Burn hazard: Do not touch the blade
immediately after use. Contact with the blade may
result in personal injury.
Pull the blade clamp lever (12) up to release
u
the blade clamping mechanism.
Remove blade.
u
Use

Switching on and off

Note: Ensure the forward reverse slider (2) is not
in the locked position.
To switch the tool on, press the variable speed
u
switch (1). The tool speed depends on how far
you press the switch.
To switch the tool off, release the variable
u
speed switch (1).
(Original instructions)
Sawing
Always hold the tool with both hands.
u
Let the blade run freely for a few seconds
u
before starting the cut.
Apply only a gentle pressure to the tool while
u
performing the cut.
If possible, work with the shoe (13) pressed
u
against the workpiece. This will improve tool
control and reduce tool vibration, as well as
prevent the blade from being damaged.
Hints for optimum use
Sawing wood
Clamp the workpiece securely and remove all
u
nails and metal objects.
Holding the tool with both hands, work with the
u
shoe (13) pressed against the workpiece.
Sawing metal
Be aware that sawing metal takes much more time
than sawing wood.
Use a saw blade suitable for sawing metal.
u
Use a fine-tooth saw blade for ferrous metals
and a coarser saw blade for non-ferrous met-
als.
When cutting thin sheet metal, clamp a piece
u
of scrap wood to the back surface of the
workpiece and cut through this sandwich.
ENGLISH
5