Fitting The Parking Aid - Dometic MagicWatch WPS 900F Manual Del Usuario

Fitting the parking aid

4.3 Painting the sensors
See fig. 6
I
NOTE
The sensors may be painted. The manufacturer recommends having the
sensors painted by a specialist workshop.
5 Fitting the parking aid
A
NOTICE!
On vehicles which feature metal reinforcement behind the bumpers, the
sensors must not be touching this reinforcement. Otherwise there is no
guarantee the parking aid will function correctly.
See fig. 7 to fig. b
Supplements fig. 8
A
NOTICE! Risk of malfunction!
Align and attach the sensor holders correctly. Otherwise there is no
guarantee the parking aid will function correctly.
The sensor holders must be attached with the retaining tabs pointing up
and down.
➤ Clean the adhesive surface on the inner side of the bumper with a primer.
➤ Apply a small amount of grease inside the sensor plug connections.
Supplements fig. a
Both the control electronics have been configured for front sensors by default.
Define the control electronics for the rear sensors as follows:
➤ Disconnect the cable bridges.
10
WPS900F/WPS910
EN