How To Assemble Your Ceiling Fan (Close To Ceiling) - Fanimation Cancun FP8042 Serie Manual Del Propietário

How to Assemble Your Ceiling Fan (Downrod)-Cont'd
6.
Cut off excess lead wire approximately 6 to 9 inches
above top of the top of the downrod. Strip insulation off
1/2 inch from the end of each lead wire. (Figure 6)
NOTE: All set screws must be checked, and retightened
where necessary, before installation.

How to Assemble Your Ceiling Fan (Close to Ceiling)

1.
Remove the three motor coupling screws from
your fan and save for step 3. (Figure 1)
2.
Route your fan wires through the ceiling canopy
and place ceiling canopy onto your motor. (Figure 2)
3.
Alight the 3 big slots in the canopy to the 3 screws
in the motor coupler. Firmly attach the canopy cover
to the motor with the three screws removed in step1.
(Figure 3)
WARNING
To avoid possible fire or shock, be sure electricity is
turned off at the main fuse box before hanging.
(Figure 4)
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
FROM DIAGRAM
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
FROM DIAGRAM
MOTOR
ASSEMBLY
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
FROM DIAGRAM
MOTOR
ASSEMBLY
6
Figure 6
Figure 1
CANOPY
CANOPY TRIM
RING
Figure 2
Screws (3)
CANOPY TRIM
RING
Figure 3
MAIN FUSE
BOX
Figure 4