Fanimation Cancun FP8042 Serie Manual Del Propietário página 7

How to Assemble Your Ceiling Fan (Close to Ceiling)-Cont'd
4.
Lift your fan motor assembly and hang it from the
hanger bracket hook through one of the two screw
holes in the canopy lip. Do not use the grooved slots.
Connect your fan's wiring according to how to wire
your ceiling fan in page 9 owner's manual. (Figure 5)
5.
Completely remove one of each screw where on
the flap of hanger bracket, and keep for reinstall in
step 7. Loose the other two screws where the canopy
is "L" slotted. (Figure 6)
6.
Lift the fan off the hanger bracket hook and mount
your fan by sliding the ceiling canopy over the mounting
bracket with the two loosened screws going into the "L"
slots in the canopy. Be sure all wiring is tucked into
the ceiling canopy and is not pinched. Once the canopy
is flush with your ceiling, turn clockwise to seat the
screws into the keyed portion of the slot. Tighten the
screws. (Figure 7)
7. Install the remaining two screws
to secure the ceiling canopy to the ceiling bracket.
(Figure 8)
8. Push the screw cover trim ring up to conceal the
screws, such that the mounting tabs seat into the
dimpled grooves in the ceiling canopy midway between
the screws. (Figure 9)
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
FROM DIAGRAM
removed in step 5
7
HOOK
MOTOR
ASSEMBLY
Figure 5
Figure 6
SCREW
SLOT
Figure 7
Figure 8
MOUNTING
TAB(4)
Figure 9
OUTLET
BOX
HANGER
BRACKET
SCREW
HANGER
BRACKET
SLOT
DIMPLEP
GROOVE
CANOPY
TRIM RING