How To Assemble Your Ceiling Fan - Fanimation Andover FP5220 Serie Manual Del Propietário

1. Prior to assembly, set aside and save the hardware bag(s)
packed in the packing.
2. Remove the Hanger Ball by loosening the setscrew in
the Hanger Ball until the ball falls freely down the Downrod.
(Figure 1) Remove the Pin from the Downrod, then remove the
Hanger Ball. Retain the Pin and Hanger Ball for reinstallation
in Step 6.
3. The fan comes with blue, black, and white 80˝ wires.
Separate and untwist the three wires. Route the wires through
the Downrod.
4. Loosen the two setscrews in the Downrod Support. Align
the Clevis Pin holes in the Downrod with the holes in the
Downrod Support. Install the Clevis Pin and secure with the
Hairpin Clip. (Figure 3) Be sure to push the straight leg of the
hairpin clip through the hole near the end of the clevis pin until
the curved portion of the hairpin clip snaps around the clevis
pin. The hairpin clip must be properly installed to prevent the
clevis pin from working loose. Pull on the Downrod to make
sure the clevis pin is properly installed.
5. Route wires through Motor Coupling Cover (Fig 2) or the
Decorative Sleeve (Fig 3) and through opening in Canopy.
Position Canopy on fan shown with open side facing up.
(Figure 4)
6. Reinstall the Hanger Ball (Figure 4) on the Downrod as
follows. Route the three 80˝ wires and support cable through
the Hanger Ball. Position the Pin through the two holes in
the Downrod and align the Hanger Ball so the Pin is captured
in the groove in the top of the Hanger Ball. Pull the Hanger
Ball up tight against the pin. Securely tighten the setscrew
in the Hanger Ball. A loose setscrew could create fan wobble.
▲WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
7. While pulling up on the hanger ball, securely tighten the
two setscrews with nuts in the downrod support.
(Figure 2 & 3)
8. Slide the Motor Coupling Cover (Fig 2) or the Decorative
Sleeve (Fig 3) down until it touches the top of the Housing.

How to Assemble Your Ceiling Fan

Hanger
Ball
Motor
Coupling
Cover
(for 6˝ or
longer
DR's)
Figure 2
Canopy
9. Before installing fan, measure up approximately 6-9 inches
above top of Downrod/Hanger Ball Assembly. Cut off excess
wire and strip back insulation ½˝ from end of wire.
10. You have now completed the upper assembly of your
ceiling fan. You can now proceed with the hanging and the
electrical wiring of your fan.
5
Pin
Setscrew
Figure 1
Decorative
Sleeve –
(for 12˝ or
longer DR's)
Clevis Pin
Hairpin Clip
Figure 3
Figure 4