How To Assemble Your Ceiling Fan - Fanimation Pearson PL8018 Manual De Instrucciones

CAUTION
To prevent damage to housing and/or blade, leave the
Ceiling Fan Assembly in its original packing during
installation of down rod, motor coupling cover and
ceiling canopy.
NOTE: Do not set Ceiling Fan Assembly on fl oor or hard
surface. Prior to assembly, set aside and save the hardware
bag(s) packed in the packing.
NOTE: If using a downrod other than what is supplied
with the fan, you must remove rubber sleeve from 6˝
downrod and put on new downrod.
1. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 3. (Figure 1)
2. The fan comes with black, white and green 80˝ wires
and a support cable. Separate and untwist the wires.
Route the wires and support cable through the
downrod with rubber sleeve. Be sure to line up the
holes while pushing the downrod with rubber sleeve
into the downrod support.
3. Install the clevis pin through the holes in the downrod
support and holes in the downrod. Secure clevis pin
with hairpin clip. Pull up on the downrod to assure the
clevis pin is properly installed.
▲WARNING
It is critical that the clevis pin in the downrod support
is properly installed. Failure to verify that the pin and
hairpin clip are properly installed could result in the fan
falling.
4. Separate the hanger bracket from the ceiling canopy
by removing two screws. Retain the two screws for later.
(Figure 4)

How to Assemble Your Ceiling Fan

(Figure 2)
(Figure 3)
Clevis Pin
6
Hairpin
Clip
Figure 1
Line up the
holes for clevis
pin installation
Figure 2
Clevis Pin
Hairpin Clip
Figure 3
Hanger
Bracket
Figure 4
Canopy