How To Assemble Your Ceiling Fan - Fanimation Cancun FP8042 Serie Manual Del Propietário

How to Assemble Your Ceiling Fan (Downrod)
1.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstal-
lation in Step 5. (Figure 1)
2. Loosen the two set screws in the downrod support
of the motor assembly. Route the black, white and blue
wires through the downrod. (Figure 2)
3. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod. Se-
cure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 3)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
4. Route wires through Motor Coupling Cover, Canopy
Trim Ring, Canopy Screw Cover and Ceiling Canopy.
(Figure 4)
5. Reinstall the hanger ball on the downrod as follows.
Route the three 80 in. wires through the hanger ball.
Position the pin through the two holes in the downrod
and align the hanger ball so the pin is captured in the
groove in the top of the hanger ball. Pull the hanger ball
up tight against the pin. Securely tighten the set screw
in the hanger ball. A loose set screw could create fan
wobble. (Figure 5)
Downrod
Set Screw
Set Screws and
Locking Nuts (2)
Canopy Trim Ring
Assembly
5
Pin
Hanger Ball
Figure 1
Black, Blue and
White Leads
Downrod
Figure 2
Downrod
Hairpin
Clip
Figure 3
Ceiling Canopy
Canopy Screw
Cover Assembly
Motor Coupling
Cover
Figure 4
Canopy Trim Ring
Figure 5