Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Befor fitting, blow out the thread in the gearbox head.
2.1.4 A
/
ttAching
detAching the grinding tool
Place the mounting flange on the spindle so that the lon-
gitudinal groove is at the bottom.
Put on the grinding tool. The projecting centring collar on
the mounting flange must engage precisely in the hole in
the grinding tool.
Lock the spindle in place with a single open ended span-
ner. Tighten the clamping nut with the face pin wrench.
Follow these instructions in reverse order to detach the
grinding tool.
Use only those tools recommended by SUHNER.
You must also observe the safety instructions issued by
the manufacturer of the attachment.
You must check that the tools diameter is within the limits
and the max speed is higher than the tool's idle or set
speed.
The installed attachment must be able to rotate freely. Af-
terwards a test run must be conducted without load for
at least thirty seconds. Vibrating tools must be replaced
immediately.
2.2 r
Ating dAtA
Connection
Maximum speed Input FSM 1:1
Maximum speed Input FSM 2:1
Maximum speed Output FSM 1:1
Maximum speed Output FSM 2:1
Gear i= FSM 1:1
Gear i= FSM 2:1
Max wheel diameter
Spindle thread
Vibration EN 60745
Weight
The specified vibration value was measured with a
standardised test method and may differ from the
actual operating value. The specified value can be
used for product comparisons or for an introductory as-
sessment of work breaks.
2.3 o
perAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 90% at +30°C, 65% at +50°C
3.
haNDLINg
3.1 w
orking instructions
To achieve an optimum grinding result, move grinding
tool uniformly back and forth with light pressure.
Excessive pressure lessens the working capability of the
hand tool, as well as the life of the grinding tool.
3.2 s
on/off
witching
Hold the hand tool firmly. Switch on the drive.
Conduct the test run without load for at least thirty
seconds. Do not use vibrating grinding tools.
You must always hold the hand tool when it is op-
erating.
Switch off the drive when you stop working.
The tool still needs time to stop after the tool has been
switched off.
Put down the hand tool so that there can be no danger.
Remove the hand tool from the shaft.
4. S
ERvICE
4.1 p
reventive mAintenAnce
Always keep the hand tool clean and in a dry
place.
Worn chucks must be replaced.
G28
8000min
-1
12000min
-1
6600min
-1
5800min
-1
1.21:1
2.06:1
178mm
M14 / 5/8"
4.7m/s
, K=1.5m/s
2
2
1.2kg
/ o
PERaTIoN
/ m
aINTENaNCE
21
Tabla de contenido
