Environmental Protection - Ryobi ESS200RS Manual De Utilización

GB
FR DE ES
switch is pressed.
MAINTENANCE
The tool should never be connected to a power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when the tool is
not in use. Disconnecting the tool will prevent accidental
starting that could cause serious injury.
When servicing use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
GENERAL
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
Do not at any time let brake À uids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
Electric tools used on ¿ berglass material, wallboard,
spackling compounds,
accelerated wear and possible premature failure because
the ¿ berglass chips and grindings are highly abrasive to
bearings, brushes, commutators, etc.. Consequently, we
do not recommended that this tool be used for extended
work on these types of materials. However, if you do work
with any of these materials, it is extremely important to
clean the tool using compressed air.
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
LUBRICATION
All of the bearings in this tool are lubricated with a
suf¿ cient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore, no
further lubrication is required.
IT NL PT DK SE
WARNING
WARNING
WARNING
or plaster are subject
WARNING
FI NO RU PL CZ
English
CLEANING THE SCRUBBING PADS
To ensure longer life and optimum performance,
periodically clean all sanding residue and foreign
materials from the scrubbing pads. This can be done
simply by rinsing the pad with warm water until all foreign
material has been washed away. After cleaning, gently
squeeze the pad to remove excess water and allow pad
to dry. Always store pads and sanding sheets À at in a cool
dry location.
CLEANING THE SANDING SHEETS
The sanding sheets that came with your sander are
made to be re-used. Therefore, it is important that they
be cleaned periodically to remove sanding residue and
foreign material that can accumulate over time.
To clean sanding sheets, rub the sheets with a hard rubber
block. You can also use the clean rubber sole of a shoe.
Always remove scrubbing or sanding pad from sander
before cleaning. Failure to do so could cause serious
personal injury.

ENVIRONMENTAL PROTECTION

SYMBOL
to
V
Hz
W
n
o
min -
1
4
HU RO LV LT EE
WARNING
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
Safety Alert
Volts
Hertz
Alternating Current
Watts
No-load speed
Revolutions or reciprocations per minute
Orbital diameter
CE Conformity
Double insulation
HR SI SK GR TR