Technical Data; Warnings; Maximum Load Product; Preparation Of The Fryer - Elframo NE-M 120 Manual Del Usuario

The connection point to the equipotential system can be reached by opening the front door and removing the collecting bin
as shown in the picture. The point is indicated by following symbol
A special device (trip-switch) must be used if connecting the fryer directly to the electricity mains supply. This device must
guarantee that the mains supply to the fryer can be cut by means of a suitable opening distance between the contacts to
ensure complete disconnection under conditions of over-voltage III, as foreseen in the rules for safe installation.
Make sure that the power cable cannot be caught or stretched.
If damaged, the power cable must be replaced by the manufacturer or its customer service or in any case by a suitably
qualified person, in order to avoid all risks. The power cable must be an "H05RN-F" or "H07RN-F" oil resistant cable. Its
2
cross-section is 5x4 mm
2 2
mm , 4x6 mm , 3x10 mm

2.2. Technical data

9
See attachment 1 (§ ).

3. Warnings

This equipment should only be used for professional use by trained personnel.
It is a deep fryer and should only be used as such, filling the tank with oil / fat suitable for frying foods placed in the baskets.
This fryer MUST NOT be used for cooking with water, or for any purpose other than that for which it has been
specifically designed. The fryer can be switched on when the tank is filled with water only to allow the machine washing
cycle described in § 5.5
With regard to airborne noise emissions produced by the fryer, the weighted sound pressure level A is less than 70dB(A).
Before using the fryer, clean the tank and the baskets of all industrial protective grease. After cleaning, make sure that the
basket support sits in the right position.

3.1. Maximum load product

The recommended maximum load of product (referring to frozen potatoes) is:

NE-M 120
For models with full basket

NE-M 200
For models with half baskets
For models with full basket
The values quoted are per single basket
4.

Preparation of the fryer

Fill the tank with oil up to a level between the minimum and the maximum sign visible on the rear wall of the tank itself.
Never exceed the maximum limit, add oil if the level is below the minimum limit.
Never start the fryer without first filling the tank.
Nominal capacity:
NE-M 200 20 liters – NE-M 120 12 liters
Notes:

When cooking food, check that the oil level never drops below the minimum level stamped on the container as this
could lead to the risk of fire.

Never let the oil get too old - always replace completely with fresh oil. Old oil reduces the flash point and increases the
tendency to boil suddenly.

Take special care when cooking bulky or undrained food as the oil could boil suddenly when these are placed in the
fryer.
. If the machine is manufactured for different power supply voltage, the cable can have section 3x4
2 2
, 5x4 mm .
............................... 600 g
............................ 500 g
.............................. 1000 g
.
Rev. 0.00 / 2017 - pag. 13 di 47
EN