Maintenance And Cleaning - Bosch AKE 30 Manual Original

OBJ_BUCH-2245-002.book Page 29 Wednesday, November 18, 2015 12:45 PM
Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your machine does not operate properly.
If these do not identify and correct the problem, contact your service agent.
 Warning: Switch off and remove plug from mains before investigating fault.
Problem Possible Cause
Chain saw fails to operate Kickback brake is activated
Plug not connected
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Chain saw operates Extension cable damaged
intermittently
External or internal wiring defect
On/Off switch 2 defective
Saw chain dry No oil in reservoir
Vent in oil filler cap 4 clogged
Oil passage clogged
Brake does not stop saw Kickback brake/run-down brake defective Contact your Bosch Service Centre
chain
Saw chain/guide bar hot No oil in reservoir
Vent in oil filler cap 4 clogged
Oil passage clogged
Chain tension too high
Dull saw chain
Chain saw rips, vibrates, Chain tension too loose
does not saw properly
Dull saw chain
Chain worn out
Chain teeth are facing in the wrong direc-
tion

Maintenance and Cleaning

 Before any work on the machine itself, pull the mains
plug.
If the replacement of the supply cord is necessary, this has to
be done by Bosch or an authorized Bosch service agent in or-
der to avoid a safety hazard.
Note: To ensure long and reliable service, carry out the follow-
ing maintenance regularly.
Regulary check the chain saw for obvious defects such as
loose, dislodged or damaged saw chain and chain bar, loose
fixings and worn or damaged components.
Check that covers and guards are undamaged and correctly
fitted. Carry out necessary maintenance or repairs before us-
ing.
Note: Before returning the chain saw, ensure all oil in the oil
reservoir has been emptied.
Bosch Power Tools
Corrective Action
Pull activation lever for kickback brake (hand
guard) 5 back in position  (see figure F)
Connect plug
Use another socket
Check cord, replace
Replace fuse
Check cord, replace
Contact your Bosch Service Centre
Contact your Bosch Service Centre
Refill oil
Clean oil filler cap 4
Clean oil passage
Refill oil
Clean oil filler cap 4
Clean oil passage
Tension saw chain
Sharpen saw chain or replace
Tension saw chain
Sharpen saw chain or replace
Replace saw chain
Reassemble with chain in correct direction
Replacing/Changing the Saw Chain and Chain Bar
Check the saw chain and chain bar according to section "Ten-
sioning the Saw Chain".
The circular groove of the chain bar will wear particularly on
the lower edge with time. When replacing the saw chain, turn
the chain bar by 180° to allow even wear, thus extending
chain bar life.
Check the drive sprocket 20. If it is worn out or damaged due
to strain, have it exchanged by an authorized Bosch after-
sales service.
Sharpening the Saw Chain
Have your chain sharpened professionally at your authorised
Bosch after-sales service or sharpen it yourself with a sharp-
ening kit suitable for the chain recommended for your chain-
saw. Observe the sharpening instructions provided with the
sharpening kit.
English | 29
F 016 L81 408 | (18.11.15)