General Safety Information; Pre-Operation - Campbell Hausfeld TL1600 Manual Del Usuario

Operating Instructions

General Safety Information

CALIFORnIA PROPOSITIOn 65
This product or
its power cord may
contain chemicals known to the State
of California to cause cancer and birth
defects or other reproductive harm.
Wash hands after handling.
GeneRAL SAFeTY
1 . Read all manuals included
with this product carefully .
Be thoroughly familiar
with the controls and the
proper use of the equipment . Follow
all instructions .
2 . Only persons well acquainted with
these rules of safe operation should
be allowed to use the unit .
Do not exceed the
maximum operating
pressure of the air tool (40 psi). This can
reduce the life of the tool.
3 . Do not exceed any pressure rating
of any component in the system .
Maximum operating pressure
of 40 psi is measured at the tool
inlet while the tool is running .
The pressure drop between the
compressor and tool needs to be
compensated for at the compressor .
4 . Disconnect the air tool from air
supply before changing tools or
attachments, servicing and during
non-operation .
Safety glasses and ear
protection must be worn
during operation.
5 . Do not wear loose fitting clothing,
scarves, neck ties or jewelry when
operating any tool . Loose clothing
or jewelry may become caught in
moving parts and result in serious
personal injury .
6 . Do not depress trigger when
connecting the air supply hose .
www.chpower.com
7 . Always use attachments designed
for use with air powered tools .
Do not use damaged or worn
attachments .
8 . Never trigger the tool when
not applied to a work object .
Attachments must be securely
attached . Loose attachments can
cause serious injury .
9 . Protect air lines from damage or
puncture .
10 . Never point an air tool at oneself
or any other person . Serious injury
could occur .
11 . Check air hoses for weak or worn
condition before each use . Make
sure all connections are secure .
Release all pressure from the
system before attempting to
install, service, relocate or
perform any maintenance.
12 . Keep all nuts, bolts and screws tight
and ensure equipment is in safe
working condition .
13 . Do not put hands near or under
moving parts .
14 . Always secure work piece in a vise
or clamp . Do not place hands on the
back cylinder when operating the
tool .
Avoid long
periods of work
with the tool. Stop using the tool if you
feel pain in hands or arms.
2

Pre-Operation

TOOLS AnD SUPPLIeS YOU WILL
neeD
u Air compressor
u Air hose and fittings
u Air powered caulk gun
u Standard 11 ounce caulk tube
u Razor knife (to cut the caulk tube)
u Long pin or nail (to puncture caulk
tube seal)
u Rags
u Ladder (if needed)
SYSTem SeTUP
Use of a whip hose
prevents accidental
triggering of tool when pressurized air
is connected to system.
Using fittings or air hoses which are too
small can create a pressure drop which
will result in a loss of power in tool .
nOTe: Do not install a quick coupler set
between tool and whip hose .
CAULk GUn SeTUP
Never carry a tool
by the hose or pull
hose to move tool or a compressor.
Keep hoses away from heat, oil and
sharp edges. Replace any hose that is
damaged, weak or worn.