Festo HSP-AE-IO Serie Manual De Instrucciones página 25

Commissioning the mechanical components
First carry out the mechanical settings:
1. Adjusting the end positions (setting the z−stroke,
setting the y−stroke).
2. Setting the rubber buffers in the event of loud stops
(only silencers).
Commissioning the electric components
(with the control panel)
1. Teaching the desired HSP mode (see overview on
next page).
2. If necessary, optimize the positioning sets via the
positioning set table.
3. If necessary, parametrize additional positioning sets
via the positioning set table.
4. Check the function of the control interface.
5. Note the instructions on operating in the detailed
manual.
Optional: Configuration with the FCT software.
Festo P.BE−K−HSP−AE−IO 0510NH English
End position travel (HSP mode 1)
End position travel with intermediate positions
(HSP modes 2...5)
25