Installation - Schulz MS 3/30 Manual Del Propietário

AIR COMPRESSOR - DIRECT DRIVE AIR COMPRESSOR - DIRECT DRIVE

INSTALLATION

INSTALLATION
1. Location:
Install the compressor in a covered, well ventilated area, free of dust, gases, toxic gases,
humidity or any other kind of pollution. The maximum ambient temperature recommended during work
0 0
is 104 F (40 C).
2. Position:
Mount at least 32 inches (800 mm) from any obstacle, to allow good ventilation during
operation and to make maintenance easier. When cabinet
4 inches (100 mm).
2.1 Compressor installation:
connection (1/4") must be joined by meas of a hose or expansible gaskets so that the charges, thermal
expansion, piping's weight, mechanical and thermal shocks or obstructions are not transmitted to the
air tank. Physical damage to the compresed air tank may occur if the above warnings are not followed.
3. Foundation/floor:
weigth plus the liquid (water) when of the hydrostatic test. The set must be level. The compressor (MS
3/30 and MSV 6/30) is equipped with rubber f
model MSV 12/100 assembly on anti-vibration, absorber (Figure 3, page 9 owner's responsibility) which,
in turn, must be placed on a concrete basis. The set must be level and the absorber must be adequate
to support the equipmentis weight and vibration.
4. Electric connection:
4.1
Consult a specialized technician to evaluate the electric supply and to select the adequate
protection and input devices.
4.2
Follow the country's technical standards on Low Voltage Electric Installations.
4.3 Fig ure 1 shows a electrical diagram for electric connections with pressure switch and fuse
(MS 3/30 and MSV 6/30).
Customer's responsibility
Main
supply
F1
P
M
1~
FIGURE 1 - ELECTRIC DIAGRAM
4.4
For your safety (see text Grounding Instructions, page 10), wire
input and grounding (see Figure 6, page 9) MS3/30 and MSV 6/30.
4.5
The electric input wires must be in accordance to the motor power, voltage and electric energy
source distance. See Table 2 for orientation.
8
When connected to the compressed air network, the discharge
It must be placed on a concrete base, which must be able to bear the equipment's
F1
P
GROUND
M
PLUG 2P+GR
MOTOR
POWER
2 x 1
TABLE 2 - ORIENTATIVE DATA ABOUT FUSES AND COPPER CONDUCTORS
15
is used, the minimum distance should be
ee t (assembled by owner's) see Figure 2, page 9. For
"D" OR "NH" FUSE
(SEE TABLE 2)
PRESSURE SWITCH
MOTOR THERMALY PROTECTED
ELECTRICAL MOTOR
VOLTAGE CURRENT
(hp) (V) (A)
115 7.6
1/2
230 3.8
115 14.0
1
230 7.0
115 2 x 14.0
2 x 7.0
230
CONDUCTOR
MÁXIMUM DISTANCE In (m)
AWG
VOLTAGE DROP (2%)
(mm ) 2
15 (1.5) 511 (13)
13 (2.5) 275 (7)
11 (4.0) 312 (8)
17
is supplied with a plug for
F1 FUSE
MAX.
(A)
25
16
35
20
80
35