Important Safety Information; Recommended Tools And Supplies; Kmm Tray Kit Contents - Dell PowerEdge 15FP Guia De Instalacion

Important Safety Information

Observe the following safety precautions when installing components in the rack:
CAUTION: You must strictly follow the procedures in this document to protect
yourself as well as others who may be involved. Your system may be very large
and heavy and proper preparation and planning are important to prevent injury
to yourself and to others. This becomes increasingly important when systems are
installed high up in the rack.
CAUTION: Rack cabinets can be extremely heavy and move easily on their
casters. They have no brakes. Use extreme caution while moving the rack
cabinet. Retract the leveling feet when relocating the rack cabinet. Avoid long
or steep inclines or ramps where loss of cabinet control may occur. Extend the
leveling feet for support and to prevent the cabinet from rolling.
CAUTION: Installing components in a rack without the front and side stabilizer
feet installed and anchored to the floor could cause the rack to tip over,
potentially resulting in bodily injury under certain circumstances. Therefore,
always install and anchor the stabilizer feet before installing components in the
rack.

Recommended Tools and Supplies

You may need the following tools and supplies to install the system in a four-post rack:
• #2 Phillips screwdriver (for installing VersaRails only)
• Masking tape or a felt-tip pen, for use in marking the mounting holes to be used

KMM Tray Kit Contents

The KMM tray kit includes the following items. See Figure 1-1.
• One 1-U KMM tray with flat-panel monitor, monitor power supply, and cable-
management arm installed; for certain regions, a keyboard with a trackball is also
installed
NOTE: If the keyboard is not shipped preinstalled in the tray for your region, you must
order a separate Dell rack-mount keyboard to complete the installation.
• One pair of RapidRails or VersaRails slide assemblies
• One monitor extension cable
• Two keyboard/trackball extension cables
• Monitor documentation
Installation Guide
1-3