Rapid Mode; Standard Mode - Nice FLOR RSL12U Instrucciones Y Advertencias Para La Instalación Y El Uso

4.1 – Storage of a transmitter
A transmitter (its code) can be stored in the memory of a
receiver in two ways:

- rapid mode

- standard mode

4.1.1 – Rapid mode
This is the quickest mode to use, but it is not extremely safe
because during the code storage operation, the receiver
may acquire a different signal from another transmitter within
its operating range and store it by mistake. We recommend
you assess this risk before selecting your storage mode.
01. Press and keep key P1 (fig. 1) on the receiver pressed:
LED L1 is turned on;
02. Press any key on the transmitter and transmit the code
until LED L1 on the receiver is turned off;
03. Then release the key on the transmitter: LED L1 is
turned back on and the receiver is ready for another
task;
04. To store the other transmitters, repeat the process from
step 02. When storage is complete, release key P1 on
the receiver.
4.1.2 – Standard mode
01. Press and release key P1 (fig. 1) on the receiver; LED L1
is turned on for 5 sec.;
02. During these 5 sec. transmit the code until LED L1 on
the receiver is turned off;
03. Then release the key on the transmitter and wait for 1
sec.;
6 - English
04. Press and keep any key on the transmitter pressed, to
send the code, until LED L1 on the receiver is turned off;
the LED will emit three flashes to indicate that the
process was successful;
If this does not happen, then repeat the process.
05. To store the other transmitters, repeat the process from
step 01.
N.B. – To avoid the storage in the receiver of a signal casual-
ly transmitted by a transmitter which has nothing to do with
the automated system in question, the BM memory can be
locked; please see paragraph 5.4.
4.1.3 – Storage of a transmitter using the procedure 'in
the vicinity of the receiver' (with a transmitter
already stored)
A NEW transmitter can be stored in the memory of the
receiver without intervening directly on the key of this receiv-
er, but simply by operating in its range of reception. To imple-
ment this procedure, you need to have an OLD transmitter at
hand, which has already been stored and is operational.
Warnings:
• The procedure must be performed while operating in
the range of reception of the receiver (10-20 m from
the receiver).
• Repeat the entire process for each transmitter you
wish to store.
01. On the NEW transmitter, keep key... pressed for at least
5 seconds. and then release it.
02. On the OLD transmitter, press key ....three times and
then release it.