DeWalt DW932 Manual De Instrucciones página 35

Edge mitre joints (fig. U1 - U4)
Outside surfaces aligned (fig. U1)
• Arrange the workpieces as they are to be
assembled.
• Mark the biscuit centres on the outside of the joint.
• Set the fence angle to 90°.
• Adjust the fence to locate the biscuit toward the
inside of the joint where the workpiece is thicker.
Select the appropriate biscuit size (fig. U2).
• Clamp the workpiece and align the tool as shown
(fig. U3).
• Cut the biscuit slots as described above.
Inside surfaces aligned
• Arrange the workpieces as they are to be
assembled.
• Mark the biscuit centres on the inside of the joint.
• Set the fence angle to 45°.
• Adjust the fence to locate the biscuit toward the
inside of the joint where the workpiece is thicker.
Select the appropriate biscuit size.
• Clamp the workpiece and align the tool as shown
(fig. U4).
• Cut the biscuit slots as described above.
T-joints (fig. V1 - V5)
This type of joints is commonly used to attach
shelves to side panels (fig. V1).
• Place the workpieces on a flat surface as they
are to be assembled (as an upside down T).
• Mark the biscuit centres on the shelf piece.
• Lightly mark the top of the shelf on the side panel
(fig. V2).
• Clamp the shelf on top of the side panel, aligning
the end of the shelf with the line (fig. V3).
• Select the appropriate biscuit size.
• Set the fence to 0°.
• Align the tool with the biscuit marks using the
markings on the tool base.
• Make a vertical (fig. V4) and a horizontal (fig. V5)
cut at each of the biscuit locations.
Consult your dealer for further information on the
appropriate accessories.
27
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
• Unplug the charger before cleaning the housing
with a soft cloth.
• Remove the battery pack before cleaning your
Power Tool.
• Keep the ventilation slots clear and regularly
clean the housing with a soft cloth.
Environment
Rechargeable battery pack
This long life battery pack must be recharged when
it fails to produce sufficient power on jobs which
were easily done before. At the end of its technical
life, discard it with due care for our environment:
• Run the battery pack down completely,
then remove it from the tool.
• NiCd and NiMH cells are recyclable. Take them
to your dealer or a local recycling station.
The collected battery packs will be recycled or
disposed of properly.
Unwanted tools
Take your tool to an authorised D
agent where it will be disposed of in an
environmentally safe way.
E N G L I S H
WALT repair
E
en - 8