DeWalt DW932 Manual De Instrucciones página 33

• Set the fence to the 0° position as described
above.
• For workpieces with a thickness of 19 mm, use
the edge of the base as a reference for centring.
• For other workpieces, use the red centreline
markings to align the tool.
• Two of the markings indicate the length of the cut.
In order to prevent breaking through the
workpiece, make sure that the workpiece extends
beyond these markings.
Plunge depth adjustment (fig. D)
The plunge depth must be set to match the biscuit
size. The numbers 0, 10 and 20 on the depth
adjusting knob correspond with the biscuit size.
The M represents the maximum cutting depth of
approx. 20 mm.
• Turn the depth adjusting knob (7) into the
required position, aligning the appropriate
number with the red marking on the tool.
Plunge depth fine adjustment (fig. E)
The fine adjustment is used to eliminate possible
tolerances in the size of the biscuit slots.
• Raise the fence (5) to its upper position as
described above.
• Insert the Torx screwdriver as shown and adjust
the plunge depth as required by turning the screw
(turn clockwise to decrease the plunge depth).
• Check the setting by making a trial cut in a piece
of scrap wood.
Anti-slipping pins (fig. F)
The anti-slipping pins (6) help to reduce the
tendency of the biscuit jointer to slide to the right
when cutting. When working on visible parts of the
workpiece, you may want to retract them in order to
avoid scratching.
• To retract the pins, rotate them slightly clockwise
using a flat screwdriver.
• To use the pins again, rotate them slightly
counterclockwise.
Replacing the blade (fig. G, H & J)
• Remove the four Torx screws (15) from the base
plate and take off the cover.
• Depress the spindle lock (9) and remove the
flange by turning it counterclockwise.
• Change the blade.
25
• Tighten the flange securely by turning it clockwise
while keeping the spindle lock depressed.
• Mount the cover plate and tighten the Torx screws.
• Make sure that the teeth of the cutter
point in counterclockwise direction as
shown (fig. H).
• After replacing the blade, always check
the cutting depth and adjust if necessary.
Dust extraction (fig. K1 & K2)
Using the appropriate adapter, you can connect
either a dustbag or a dust extractor.
Dust extractor
• Insert the appropriate adapter (16) or (17) into the
dust extraction outlet (4).
• Connect the dust extractor hose to the adapter.
Dustbag
• Insert the straight adapter (16) into the dust
extraction outlet (4).
• Attach the dustbag (18) to the adapter.
• Whenever possible, connect a dust extraction
device designed in accordance with the relevant
regulations regarding dust emission.
Instructions for use
Always observe the safety instructions
and applicable regulations.
Switching on and off (fig. B)
• To run the tool, press the on/off-switch (1).
• To stop the tool, release the switch.
Do not switch the tool on or off when the
blade touches the workpiece or other
materials.
Making biscuit joints
General (fig. L)
Various techniques can be used to make strong and
accurate biscuit joints. In this manual, the most
important techniques will be discussed in more detail.
E N G L I S H
en - 6