2.2.2 Installing Changeover Module
Note
Observe general information as well as the safety information provided in Section 1.
a
The installation procedure for the changeover module in conjunction with navigation Mark IIi is described for
LHD vehicles only.The installation kit navigation Mark IIi is not offered for RHD vehicles.
c
Preparation
Print out fault code memory
Disconnect battery
Remove front left entrance strip
Remove cover under instrument panel in footwell, left
Remove bottom left A-pillar trim panel
Remove (expose) left door isolating connector
Fold back carpet (expose ground terminal point) in footwell area on left
Open out fold-out page! (Page 2-99)
Fig. A
The figure shows the front left entrance from the inside:
Connect branch A1, black 2-pin pin housing, from changeover module A to black 2-pin socket housing (2) of
navigation wiring harness (3).
Connect branch A2, 1-pin socket contact, white/brown wire, from changeover module A to PIN 2 of supplied black
2-pin socket housing (1).
Connect branch A3, 1-pin socket contact, red/white wire, from changeover module A to PIN 1 of supplied
black 2-pin socket housing (1).
Firmly secure branch A4, 6 mm cable eye, brown wire, from changeover module A at ground terminal point X173 in
footwell area on left.
Connect branch A7, black 3-pin pin housing, from changeover module A to black 3-pin socket housing (4) of
navigation wiring harness (3).
Tie back supplied black 2-pin socket housing (1) with connected branches A2 and A3 from changeover module A
on vehicle wiring harness (not required).
Fig. B
The figure shows the front left entrance:
b
Follow specified order.
c
The two supplied shrink-fit tubes (1) must be fitted on branches A9, 1-pin socket contact, blue wire, and A10,
1-pin socket contact, blue/brown wire.
Fig. C
The figure shows the front left entrance:
Release black 8-pin speaker connector X18196 from door isolating connector (1) as illustrated and slide out.
Fig. D
The figure shows the front left entrance:
Unplug pin contact (1) of speaker cable (2), blue/white wire, from PIN 28 of black 8-pin speaker connector X18196.
Connect unplugged 1-pin pin contact (1), blue/white wire, of speaker cable (2) to branch A9, 1-pin socket contact,
blue wire, from changeover module A.
2-86 EN
Capítulos
