Operation; Quick Control - Abicor Binzel WH-Interlock Instructivo De Servicio

Alignment jig
The adjusting sleeves are torch-specific and are fastened differently:
Plugged on
M23x1.5
M24
M22x2
M12x1 / M14x1
G 1/4"
3/4" - 16G UNF
Tab. 6
The measuring sleeves are torch-specific and have different threaded stems:
M8
M6
M10
M7
M10x1
Tab. 7
1 Screw in the measuring sleeve (13) at the position of the contact tip.
2 Plug on/screw in the adjusting sleeve (14) at the position of the gas nozzle.

6 Operation

NOTICE
Before inserting the torch into the alignment jig, check:
• Whether the correct interface and the corresponding torch are inserted.
• Whether the dust and welding spatters are removed. This might cause wear and reduced test

6.1 Quick Control

1 Remove the neck liner and the wire guide.
2 Fasten the change neck torch into the clamping device.
1
Abb. 3
3 Move the test madrel (1) to the contact tip (2).
The bending angle is correct if the tip of the test mandrel (1) and the contact tip (2) are centered.
BAL.0022 • 2017-02-15
WH 241/242, ROBO VTS 500,
WH 455
ROBO VTS 500 TS,
ROBO VTS 290
ABIROB
ABITIG-WH 220 W/220 WS
ABITIG-WH 400 W/400 WS
Adjusting sleeves
WH 455, WH 505/505 TS, ROBO VTS 0/500 TS,
WH 241/242, ROBO VTS 500/500 TS, ROBO VTS 290, ABITIG-WH
WH 650/652
WH cold wire / laser
ABIROB
Adjusting sleeves
accuracy.
1
Test mandrel
Quick Control
ABIROB
®
W 500 TS
ABIROB
®
A 360/500
®
350 GC
2
2 Contact tip
6 Operation
®
350 GC
®
W 500 TS
ABIROB
EN - 9