Adjustments - RIDGID R4030 Manual Del Operador

ADJUSTMENT
WARNING:
Before performing any adjustment, make sure the
tool is unplugged from the power supply and the switch is in the OFF position. Failure to heed this
warning could result in serious personal injury.
The saw has been adjusted at the factory for making very
accurate cuts. However, some of the components might
have been jarred out of alignment during shipping. Also,
over a period of time, readjustment will probably become
necessary due to normal wear.
Do not start any adjustments until you have checked with
a square and made test cuts to be sure adjustments are
needed.
TO SQUARE THE CUTTING WHEEL TO THE
TABLE
See Figure 28.
Do not loosen any screws for this adjustment until you have
checked with a square and made test cuts to be sure adjust-
ments are necessary. Once the screws are loosened, these
items must be reset.
 Unplug the saw.
 Using a hex key, loosen cap bolts on the left rail.
 Place a framing square against the fence and the flat part
of the wheel.
 Move the rail until the fence is square with the cutting
wheel.
 Tighten the cap bolts securely.
TO ADJUST THE LOWER TABLE ROLLERS
See Figure 29.
If the table doesn't slide smoothly, seems too loose on the
rails, moves side to side, or is visibly off track adjustments
may be required.
To adjust if the table is loose:
 Loosen the cam bolt nut.
 Insert hex key through the hole in the left side of the table
and adjust bolt as needed.
 Once the rollers are touching the rail, tighten the cam bolt
nut securely. Repeat for each roller as required.
NOTE: Check that rollers are sliding properly after each
adjustment.
CAP
BOLTS
FRAMING
SQUARE
21 — English
CAM BOLT
NUT
Fig. 28
Fig. 29