RIDGID R4030 Manual Del Operador página 13

ASSEMBLY
 Place spacers in the side holes of the frame as shown in
figure 7.
 Insert socket head screws through the motor head
assembly, spacers, and into the side of the frame. Finger
tighten then lightly torque using wrenches.
 Once all screws are lightly torqued, return to the first three
screws and tighten. Tighten the two screws on the side
of the frame last.
 Place the frame on the water tray as shown in figure 8.
INSTALLING THE SLIDING TABLE
See Figures 9 - 10.
To Unlock the Sliding Table:
 From the right side of the table, pull the table lock lever
out and turn the lever toward the back of the saw.
SOCKET HEAD
SCREW
SPACER
WATER
TRAY
HEX NUT
Fig. 7
WATER TRAY
FRAME
Fig. 8
13 — English
To Install the Sliding Table:
 Grasp the table firmly and set the rollers on the left side
of the sliding table on the rails first then place the rollers
on the right side of the frame.
 Holding the table parallel with the frame, push the table
toward the back of the saw.
 When the table lock lever reaches the stop on the front
rail on the right hand side of the frame, pull the lever out
and hold it out until the lock has passed the stop. Release
the lever.
 Slide the table along the rails until the final rollers engage
the rails.
To Lock the Sliding Table:
 Turn the table lock lever until the lever points "up".
 Release the lever.
NOTE: When the table is installed on the water tray frame
and you push the table, it will "click" into place. This is the
table lock lever snapping into a hole in the frame locking
the table in place.
TABLE LOCK
LEVER
LOCK
ROLLERS
UNLOCK
Fig. 9
SLIDING
TABLE
SAW
FRONT
Fig. 10