RIDGID R4030 Manual Del Operador página 22

ADJUSTMENT
POSITIVE STOP ADJUSTMENTS
See Figure 30.
NOTE: These adjustments were made at the factory and
normally do not require readjustment.
 Unplug the saw.
If the wheel is not perfectly vertical (0°):
 Loosen the bevel lock knob.
 Raise the motor head.
 Place a combination square beside the wheel.
 Using a wrench, turn the 0° hex bolt until the wheel is
square to the table and the hex bolt is resting on the saw
housing.
 Tighten the bevel lock knob.
If the wheel is not an exact 45°:
 Set the saw arm to a 45° angle.
 Place a combination square beside the wheel and set the
saw arm at 45°.
 Using a wrench, turn the 45° hex bolt until the hex bolt
is resting on the saw housing.
TO ADJUST THE LASER GUIDE
See Figure 31.
DANGER:
Laser radiation. Avoid direct eye contact with light
source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein can
result in hazardous radiation exposure.
NOTE: Avoid direct eye exposure when using the laser guide.
 Use the work clamp or a C-clamp to secure a piece of
scrap tile.
 Plug the saw into the power source and make a slight
cut to score the tile.
 Turn the saw OFF and allow the saw blade to stop rotat-
ing before raising the wheel.
 Raise the motor head.
 Unplug the saw.
 Turn on the laser.
 To adjust the laser line, loosen the Phillips head screw,
adjust the laser module as needed, and tighten the screw
securely.
 Once aligned, close and lock the wheel guard.
NOTE: Always make practice cuts on scrap material before
cutting through your workpiece.
45°
BEVEL
LOCK
KNOB
SCREW
LASER GUIDE
SWITCH
22 — English
COMBINATION
45
0°
SQUARE
Fig. 30
Fig. 31